Clean hands, sometimes called the clean hands doctrine or the dirty hands doctrine, is an equitable defense in which the defendant argues that the plaintiff is not entitled to obtain an equitable remedy because the plaintiff is acting unethically or has acted in bad faith with respect to the subject of the complaint—that is, with "unclean hands". The defendant has the burden of proof to show the plaintiff is not acting in good faith. The doctrine is often stated as "those seeking equity must do equity" or "equity must come with clean hands". This is a matter of protocol, characterised by A. P....

In the United States, the exclusionary rule is a legal rule, based on constitutional law, that precludes evidence collected or analyzed in violation of the defendant's constitutional rights from being adduced in a court of law. This may be considered an example of a prophylactic rule formulated by the judiciary in order to protect a constitutional right. The exclusionary rule may also, in some circumstances at least, be considered to follow directly from the constitutional language, such as the Fifth Amendment's command that no person "shall be compelled in any criminal case to be a witness against...

Fruit of the poisonous tree is a legal metaphor in the United States used to describe evidence that is obtained illegally. The logic of the terminology is that if the source (the "tree") of the evidence or evidence itself is tainted, then anything gained (the "fruit") from it is tainted as well. == History == The fruit of the poisonous tree doctrine was first described in Silverthorne Lumber Co. v. United States, 251 U.S. 385 (1920). The term's first use was by Justice Felix Frankfurter in Nardone v. United States (1939). Such evidence is not generally admissible in court. For example, if a police...

Computer numerical control (CNC) is the automation of machine tools by means of computers executing pre-programmed sequences of machine control commands. This is in contrast to machines that are manually controlled by hand wheels or levers, or mechanically automated by cams alone. In modern CNC systems, the design of a mechanical part and its manufacturing program is highly automated. The part's mechanical dimensions are defined using computer-aided design (CAD) software, and then translated into manufacturing directives by computer-aided manufacturing (CAM) software. The resulting directives are...