« first day (1006 days earlier)      last day (4194 days later) » 

11:29
I've seen two flags on this one, is it really that bad of an answer? It's not good, but he seems to be saying that older homes didn't have a grounding rod requirement so adding grounding rods may fix a problem from getting an electric shock from the screw on your light switch.
0
A: Why did I feel an electric current when touching my light switch?

stevethat age home probably does not have ground rods. those days grounds and neutrals tied together in main panel. ccode says two 8' less than ten feet apart tied together then connected to ground strap (existing or added) in main panel. then if need be separate neutral and grounds in panel. doing al...

 
2 hours later…
13:52
interest in this question?
0
Q: Outlet Installation--more wires than my new outlet can use

AndrewI am replacing a wall outlet with a Cooper Wiring USB outlet (TR7745). The new outlet has 3 wires coming out of it--a black, a white, and a green. Each one needs to be attached with a wire nut to the appropriate wires. The trouble is that there are 5 wires (2 white, 2 black, a a ground). My f...

14:06
@Kortuk sure, send it over.
@BMitch and what about this:
-4
Q: Where can I purchase this part?

Ellen StefanitsI have the exact same light problem for my swimming pool made by Pentair Water. They won't sell me just the transformer. Any answers to where I can purchase one? Sorry typo voltage regulator 680001 B 120V-60Hz-35VA/12v part# OBJY2 130R2 EIA172-0753

@Kortuk no thanks, we're a bit anal on the shopping questions here. :)
@BMitch there is a reason I had not migrated it, I did not think you would do the outlet one honestly, but that gives me a better idea of your limits. :)
@Kortuk It's part of the home, we do outlets all the time. It might be a dup, but we've got a lot of those around here.
@BMitch kk.
@BMitch sorry, at least one of those has a post from our long time spam user.
14:12
@Kortuk I cleaned up a reference to a user that was missing, so that may have been the spam answer/comment.
@BMitch Yep.
15:06
@BMitch you on?
@Jason yup, what's up?
would the load side to the other outlets be considered a branch circuit?
I'm being quite picky here but "Disconnecting these from each other breaks the circuit, resulting in no power to the other devices in the room." Since the power is run in parallel it does only break the circuit after that connection, I know that is mentioned but it was confusing to me to read. Had to reread the entire sentence to make sense of it.
@Jason I don't think that's a branch circuit, 1 in and 1 out would be a normal wiring for anywhere by the end of a circuit. You'd need 1 in and 2 out for a branch. Unless my understanding is wrong.
@Jason I'm often confusing in what I write, far too scatter brained these days.
I modified the comment to be a little more clear, I think.
15:25
I only work on my stuff and friend's so my terminology is terrible
It sounded to me like it may be a branch circuit but wasn't sure on the proper term for "load feed" outlets
 
5 hours later…
20:03
@Jason The whole thing is a branch circuit. The branch circuit begins at the final overcurrent device, and ends at each outlet (outlet as in a point where power can be taken, not outlet as in a synonym for receptacle).

« first day (1006 days earlier)      last day (4194 days later) »