« first day (4897 days earlier)      last day (15 days later) » 

Criggie
Criggie
10:25 AM
Sketchy-as frig workholding in the lathe
Yes, that is an ER20 collet holding a pin which is also clamped into a three-jaw drill chuck.
Why? Because I had no other way to hold the drill-chuck and access all the outside surfaces for cleaning.
It only needed a derusting and light sanding - I was not cutting metal off the drill chuck like this.
 
 
1 hour later…
Journeyman Geek
Journeyman Geek
11:28 AM
o0
 
Journeyman Geek
Journeyman Geek
11:55 AM
@Criggie I feel like the 'easy' option here would be to soak it in something derusty :D
(I think handtool rescue swears by evaporust, I've used vinegar for non precisionish small item derusting)
 
 
7 hours later…
Criggie
Criggie
6:58 PM
I did the ultrasonic, but that only loosens things, doesn't remove it.
And circular things are so much easier to clean in the lathe or a drill
 
 
3 hours later…
Criggie
Criggie
10:03 PM
Bah - power outage at home, so images won't load.
 

« first day (4897 days earlier)      last day (15 days later) »