@0scar - I thought it was kind of kewl, especially since you know the orientation of the print to the printer ... no surprises. I'm sure the author of the mod surely must have put some work into it.
@Greenonline Personally, I don't think so. The answers discuss the solution, it is Ilya who fails to implement them. Pin assignment is not that difficult, you can swap X and E or whatever by reassigning the pins. I guess that he doesn't have much experience in software/firmware development. Therefore I marked it a duplicate.
:)
@Pᴀᴜʟsᴛᴇʀ2 Yeah, indeed interesting, and a lot of time it must have cost to make. But, in the end, it is nothing more than tweaking the accelerations and speeds to fit this machine.
@Greenonline By not accepting it is already implied that it did not work for him, but others can use the answers to solve their problem. Please note that I have tested swapping steppers, it works.
In that sense, his comments direct the readers away from the solution, while the solution works
@0scar Convert to comment was an option on the mod page, so instead of deleting it, leaving it as a comment seemed nicer. Is it a valid comment, or not, I'm not sure? I'm still trying to wake up... :-)
@Greenonline No prob, just teasing! But this way my honest flag gets disputed while in fact it wasn't an answer, it was a comment, not your fault, it is a system thing!
@Greenonline I forgot it is way more early over there than here! ;) Good morning!