I was trying to install ubuntu in an external disk, when i make the partitions, it says 'failed to format ext4'.
I tried with an older ubuntu version, and another distro and same error.
I disabled the secureboot.
The partitions i made are:
-efi 300 MB.
-/ 50 GB.
-Swap 8 GB.
Home rest.
I tried to ...
I have a Seagate Firecuda drive that appears to be working, but I cannot get smartctl information on it... is it that this particular drive does not support smartctl or something else?
Using lshw I see the device:
*-storage
description: Non-Volatile memory c...
I'm new to KVM virtualization and I have a bunch of VM's but I want to passthrough a GPU to a VM. My MB supports IOMMU and it's enabled but I have only one GPU on this PC because is headless and MB need a GPU to boot. Can someone help me with this or post an tutorial ?
Thanks in advance.
Hey people. I just wanted to know, which is the right place to ask questions about the chat? Is it Meta Ask Ubuntu or Meta Stack Exchange or somewhere else?
@technastic_tc you can ask on our meta, unless the issue is specific to using the chatrooms of a site other than Ask Ubuntu, but since chat is global it would be relevant on MSE too.
I use the CORE network emulator. I try to run Wireshark on one of the nodes via the terminal, but I get this error:
QStandardPaths: XDG_RUNTIME_DIR not set, defaulting to '/tmp/runtime-root'
qt.qpa.screen: QXcbConnection: Could not connect to display
Could not connect to any X display.
On the h...
I had a problem, so I have asked a Question here.
Then later on I have found out how to solve it, so I was going to post an Answer.
I was prevented to post the answer with a message: Please see the error above, but there was actually nothing highlighted/stated/suggested above or below or anywhere...
I have a Seagate Firecuda drive that appears to be working, but I cannot get smartctl information on it... is it that this particular drive does not support smartctl or something else?
Using lshw I see the device:
*-storage
description: Non-Volatile memory c...
I'm new to KVM virtualization and I have a bunch of VM's but I want to passthrough a GPU to a VM. My MB supports IOMMU and it's enabled but I have only one GPU on this PC because is headless and MB need a GPU to boot. Can someone help me with this or post an tutorial ?
Thanks in advance.
I use the CORE network emulator. I try to run Wireshark on one of the nodes via the terminal, but I get this error:
QStandardPaths: XDG_RUNTIME_DIR not set, defaulting to '/tmp/runtime-root'
qt.qpa.screen: QXcbConnection: Could not connect to display
Could not connect to any X display.
On the h...
The notorious updates keep showing up in Ubuntu 20.04. Is there any way to disable them?
